Pointing is the mortar visible in the joints between bricks. It protects the wall from rain, and when it fails, water gets in, bricks get damaged and damp appears inside. Repointing is one of the most common jobs on older Grimsby and Cleethorpes houses, and one of the most commonly done badly.
Signs a wall needs repointing
- Mortar recessed more than about 5 mm behind the brick face
- Mortar that crumbles or turns to sand when you scrape it with a key
- Gaps, cracks or missing joints, often worst under sills and around chimneys
- Plants growing out of the wall
- Damp patches inside on exposed walls after rain
- Brick faces flaking off (spalling), which often means the wrong mortar was used before
Lime or cement?
This is the most important decision in repointing.
| Lime mortar | Cement mortar | |
|---|---|---|
| Typical buildings | Most houses built before about 1920 (solid walls) | Most houses built after about 1945 (cavity walls, harder bricks) |
| How it works | Softer and more breathable than the brick. Moisture escapes through the joints. | Hard and dense. Suits modern hard bricks. |
| If used on the wrong wall | Can wear faster on very exposed modern brickwork | On old soft brick it traps moisture, so faces spall and damp increases |
The rule is simple: the mortar should always be weaker than the brick. When it's the other way round, the brick takes the damage instead of the joint, and bricks are much harder and dearer to replace than pointing.
Many older terraces in the area have been repointed in hard cement at some point. If you see bricks crumbling around neat, proud cement joints, that's why. Raking out cement from soft bricks needs care, and sometimes it's better to leave sound areas alone and repair the worst ones.
How good repointing is done
- Rake out joints to at least twice their height (usually 15 to 25 mm), by hand or with care, without widening the joints or chipping bricks.
- Brush out and dampen the joints so the new mortar bonds.
- Fill in layers on deep joints, pressing the mortar in firmly.
- Finish to match the original style: flush, bucket handle, weathered or recessed.
- Protect from sun, rain and frost while it cures. Lime work especially needs protecting for days, and shouldn't be done in winter.
Watch out for
- Thin "smeared" pointing over the top of old joints that haven't been raked out. It falls off within a few years.
- Angle grinders cutting into the bricks and widening joints.
- Mortar colour that doesn't match. Lime and sands can be blended to match the original.
Need repointing done? See our brickwork and repointing service.
