Damp is the most common problem we're asked to look at, and the most commonly misdiagnosed. Most damp in houses isn't "rising damp" at all, and the right fix depends completely on the cause. Get it wrong and you can spend thousands without solving it.
The three main types of damp
1. Condensation (the most common)
Warm, moist air from cooking, showers, drying clothes and breathing hits cold surfaces and turns to water. Signs: black mould in corners, behind furniture and on window reveals; streaming windows in the morning; worse in winter; worse in bedrooms and bathrooms.
Fix: reduce moisture (lids on pans, extractor fans that actually work, no drying clothes on radiators), ventilate (trickle vents open, windows cracked after showers), and heat steadily. Improving insulation on cold walls helps long term.
2. Penetrating damp
Water getting in from outside: through failed pointing, cracked render, leaking gutters and downpipes, defective flashings, blocked cavity walls or a leaking roof. Signs: patches that appear or grow after rain, often high up or below a specific defect outside, worse on the walls facing the weather.
Fix: find and repair the outside defect, such as repointing, gutter repairs or flashing replacement, then let the wall dry out.
3. Rising damp
Ground moisture drawn up a wall because there's no damp-proof course or it has been bridged. Genuine rising damp is much rarer than many surveys suggest. Signs: a tide mark up to about a metre high, salts (white fluffy deposits) on the plaster, and damage to skirting boards.
Fix: first check whether the existing damp-proof course is being bridged, which is very common. Bridging happens when outside ground or paving is built up above floor level, render runs down to the ground, rubble sits in the cavity, or there's hard plaster inside. Removing the bridge often solves it without chemicals.
Older solid-walled houses need to breathe
Thousands of homes in Grimsby and Cleethorpes are Victorian and Edwardian, with solid brick walls built in lime mortar and finished with lime plaster. These walls were designed to absorb some moisture and let it evaporate again. Problems start when they're "sealed" with:
- hard cement repointing on the outside
- cement render or non-breathable masonry paint
- gypsum plaster, vinyl paint or plastic-based finishes inside
Trapped moisture then appears as damp patches, failing plaster and crumbling brick faces. The fix is often to remove the non-breathable materials and replace them with lime, not to add more barriers.
Signs you need help
- Damp that keeps coming back after decorating
- Rotten skirting boards or springy floors (check for wet or dry rot)
- Damp after a leak, flood or works next door
- A survey recommending chemical injection when the cause hasn't been explained
We'll investigate, explain the cause in plain English and repair it properly. Our maintenance service covers damp repairs for homeowners and landlords.
